Case Mod : Walnut

Skouperd · Post by **Skouperd** » Mon Sep 23, 2013 10:43 am

Still work in progress... but figured since I have the back panel all worked out, I'd post a picture.[ATTACH]508[/ATTACH]

comments:
1. I am using half blind, variable space, dove tails to attach the top panel to the back panel. You can see the pins in the picture on the top.

2. The IO' shield is sunked in and cut to such dimensions that the IO plate is held in place by nothing more than friction alone. Ie. same as in any metal case.

3. The top right cut-out is 120mm by 120mm suitable for either a 120mm fan or a 120mm watercooler, both capable to be held in place by friction alone.

4. PCI slots have been trimmed down as to allow easier airflow and cut from the same piece of wood as the back panel (i.e. no inserts). The PCI slots is about 4mm high and about 3mm wide. Thereby compliant with ATX2.0 standards.

5. The bottom hole is for the power supply. The design is different than the previous case made from wood (http://blog.skoups.com/?p=272) in that the PSU is bottom mounted and not side top mounted as per the Mahogany case.

More pictures will follow and if everythign goes according to plan, the case should be ready for rAge 2013.

Skouperd · Post by **Skouperd** » Mon Sep 23, 2013 10:53 am

Post by **TygerBS** » Mon Sep 23, 2013 10:53 am

Looking good dude!

flycatchr · Post by **flycatchr** » Mon Sep 23, 2013 10:57 am

looking forward to seeing it

Post by **Megageth** » Mon Sep 23, 2013 11:01 am

I imagine making wooden pc cases can be very satisfying.

Post by **SlipperyDuck** » Mon Sep 23, 2013 11:04 am

I'm just looking, and I prefer eating walnuts

Morphza · Post by **Morphza** » Tue Sep 24, 2013 6:59 am

Looking good, what's the expected weight on completion?

Skouperd · Post by **Skouperd** » Wed Sep 25, 2013 12:16 am

Morph, all i can say is that i have learnt a lesson on the mahogany built which i think is coming in at about 35kg (if not more) with all its drives installed. I recon this one should come in at about 15kg fully setup. Bear in mind that it will only have one or two 2.5" drives, also it is a lot smaller than the previous built.

Mega you are so correct! I am not sure what is more fun, designing it , building it, or playing on it. What i can definatly confirm carry it around is not fun!

Skouperd · Post by **Skouperd** » Wed Sep 25, 2013 9:02 am

A close up of the half blind dovetail joints as seen from the front.
[ATTACH]510[/ATTACH]

The pieces of wood is starting to look like the resemblance of a pc case.
[ATTACH]511[/ATTACH]

I am treating the wood with Danish low lustre oil.

Skouperd · Post by **Skouperd** » Thu Sep 26, 2013 9:57 am

Progress now is slow because of the time lapse between oil coats.