Megageth
06-11-2009, 02:36 PM
NB This is largely based on guides on the myBB forum (http://mybroadband.co.za/vb/showpost.php?p=2753845&postcount=2753845).
1. Router in bridged mode.
2. Download and install the following registry key (http://www.quickshare.co.za/files/v2mxeto9/WanEndPoints.reg.html) (will increase your WAN points).
3. REBOOT!
4. Create 2 dialup connections for your ISP account details, label them accordingly.
> Control Panel
> Network and Internet
> View Network Status and Tasks
> Setup a new connection or Network
> etc etc
5. Go into the properties of both dial-up connections, go to the Networking Tab and:
> Disable IPv6 (uncheck the tick box)
> Go to the Properties of IPv4 and then click on the "Advanced" button.
> Deselect the option that says "Use default gateway on remote network".
> Click "OK" until all the windows have gone.
6. Download and install RouteSentry here (http://antibody-software.com/web/software/software/route-sentry-:-local%10international-traffic-router-utility/).
7. Using the dropdowns, select the dialups to use for local + international.
8. To test, open the following links in 2 different tabs and compare IP's - they should be different:
> http://www.whatsmyip.co.za/ (local)
> http://www.whatismyip.com/ (International)
* I tried a lot of variations on setups to get mine working, pls can someone test this list and see if I have left anything out.
1. Router in bridged mode.
2. Download and install the following registry key (http://www.quickshare.co.za/files/v2mxeto9/WanEndPoints.reg.html) (will increase your WAN points).
3. REBOOT!
4. Create 2 dialup connections for your ISP account details, label them accordingly.
> Control Panel
> Network and Internet
> View Network Status and Tasks
> Setup a new connection or Network
> etc etc
5. Go into the properties of both dial-up connections, go to the Networking Tab and:
> Disable IPv6 (uncheck the tick box)
> Go to the Properties of IPv4 and then click on the "Advanced" button.
> Deselect the option that says "Use default gateway on remote network".
> Click "OK" until all the windows have gone.
6. Download and install RouteSentry here (http://antibody-software.com/web/software/software/route-sentry-:-local%10international-traffic-router-utility/).
7. Using the dropdowns, select the dialups to use for local + international.
8. To test, open the following links in 2 different tabs and compare IP's - they should be different:
> http://www.whatsmyip.co.za/ (local)
> http://www.whatismyip.com/ (International)
* I tried a lot of variations on setups to get mine working, pls can someone test this list and see if I have left anything out.